Login Register

H18CE-0800C PTN CPE


Overview

H18CE-0800C PTN(Packet Transport Network) CPE(Customer Premise Equipment ) device from Beijing Huahuan Electronics Co., Ltd, on the basis of high-performance L2 switch service, provides convenience of maintenance and deployment,multi-service support, carrier-class OAM management, reliable protection mechanism, QoS policy, security mechanism, and other service optimization measures. Meanwhile, it features excellent extensibility and reliability. It provides 8 GX interface, 1 RJ-45 NM port and 1 CONSOLE port.

H18CE-0800C supports the latest carrier Ethernet attributes and is compatible with IEEE, ITU, and MEF standards. This series of devices apply packet transmission technology,support complete OAM function, convenient for network management and maintenance, the carrier-class OAM has enhanced network management capacity and meets the operator’s requirements for comprehensive and powerful capacity of monitoring and management. QoS function has extended the scope of carrier Ethernet, applying it to real-time service, i.e. voice and video. S-VLAN ID is used to implement VLAN extensibility and provides service for hundreds of enterprise users and hundreds of thousands of individual users.

H18CE-0800C supports IEEE 1588v2 protocol technology, MPLS-TP technology, complete alarmand performance management function.

Features

² IEEE802.1Q VLAN, IEEE802.1ad VLAN (at most4094 VLAN entries);

² Ethernet OAM protocols including IEEE802.3ah, IEEE 802.1ag and ITU-T Y.1731;

² STP/RSTP/MSTP (Spanning Tree Protocol/RapidSpanning Tree Protocol/ Multiple Spanning Tree Protocol);

² Link aggregation (manual LAG and static LACP (LinkAggregation Control Protocol));

² ELPS (Ethernet Linear Protection Switching);

² ERPS (Ethernet Ring Protection Switching);

² QoS function based on port speed limit, portmirror, priority trust, flow classification, flow policy, priority mapping, and queue scheduling and so on;

² Interface protection;

² Jumbo frame setting (maximum 9720 bytes);

² Flow control;

² SLA ( Service Level Agreement );

² DDM (Digital Diagnosis Monitoring);

² MAC Address forwarding control;

² Static and dynamic ARP;

² IEEE 802.1X authentication;

² ACL (Access Control List);

² Broadcast storm repression;

² Remote in-band monitoring management;

² IEEE 1588v2 time synchronous;

² MPLS-TP, including LSP (Layered ServiceProvider), L2VPN, PWE3 (Pseudo-Wire Emulation Edge to Edge), MS-PW, MPLS VLAN switch;

² DHCP (Dynamic Host Configuration Protocol) client;

² Power failure alarm;

² Ezview network management, SNMP V2&V3, and CLI;

² In-band and out-band network management setup, telnet client and console interface;

² NTP (Normal Temperature and Pressure)V1/V2/V3 and RMON (Remote Network Monitoring);

² Upgrade of software through FTP and TFTP (TrivialFile Transfer Protocol).

Typical application

Functions

Item

Descriptions

Management  

In-band  and out-band NM interface setup, telnet client and console port, SNMP V2C/V3,  EzView GUI NMS.

IEEE  802.1ah

Dying  gasp, link fault, remote loopback

Ethernet  OAM

IEEE  802.1ag, Y.1731, performance monitoring and fault management, including  CC/LB/LT/AIS/LCK/MD/MA/MEP/RME/fault ACK, frame delay measurement, RFC2544  test and in-service test.

RMON

Remote monitoring,  1/2/3/9 group MIB

Upgrade

Through  FTP/TFTP

Statistics  

Based on  port, RFC1213 standard error frame statistics

MPLS-TP

MPLS-TP  FLOW, MPLS-TPLSP, MPLS-TP TUNAL, CLEAR FLOW STATISTICS, MPLS-LSP OAM,MPLS-TP  PW OAM, MPLS-TP segment OAM, protection switch

1588V2

Support  OC/BC/TC, L2 PTP, modify sync/delay-resp/announce message sending interval,  time delay compensation function, BMC, slave-only in OC mode, one 1PPS+TOD  interface, E2E/P2P, one step/two step

Link  aggregation

Six load  sharing algorithms: S-MAC, D-MAC, S-MAC+D-MAC, S-IP, D-IP and S-IP+D-IP.

VLAN

IEEE  802.1Q, most 4094, access/trunk/hybrid mode

Q in Q

Basic  and flexible VLAN, support VLAN switch, outer TPID and inner TPID

Congestion  control

WRED(Weighted  Random Early Detection), discarding ratio 1%-100%

ARP

Static  and dynamic

DHCP  client

IPv4/IPV6

DDM

Monitor optical  port connection status and quality and the intelligent optical module’s  emission optical power, reception optical power, temperature, work voltage,  laser offset current, and other parameters.

Flow  control

IEEE802.3x  under full-duplex

LLDP

Based on  IEEE 802.1ab, NMS can quickly master topology and changing conditions of  layer-2 network.

SYSLOG

System  log server information and table

ELPS

G.8031

ERPS

G.8032,wrapping  and steering protection revert, ≤50ms

QoS

CoS  priority, DSCP priority, SP/WRR/DRR/SP+WRR/SP+DRR

ACL

IP ACL,  MAC ACL,USER ACL,FILTER,ACL MAP

SLA

L2/L3  SLA, L2 network latency/jitter testing, L2 discarding testing

Specifications

10/100/1000 Base-Tx Interface

Interface  specifications

Complying  with IEEE 802.3, IEEE-802.3u, IEEE 802.1Q, IEEE 802.1p

Interface  rate

10M/100M/1000M

Operation  mode

Auto-negotiation,  1000M full-duplex, 1000M half-duplex, 100M full-duplex, 100M half-duplex, 10M  full-duplex, 10M half-duplex

Interface  connector

RJ-45 socket

Interface  number

8

100/1000Base-Fx Interface

Interface specifications

Complying with IEEE 802.3, IEEE-802.3z, IEEE 802.1Q, IEEE 802.1p, IEEE802.1ad, IEEE802.1d, IEEE802.1w, IEEE802.3ad, IEEE802.3ah, IEEE802.1ag, Y1731

Interface  rate

100M/1000M

Operation  mode

Auto-negotiation,  1000M full-duplex, 100M full-duplex

Interface  connector

SFP socket

Interface number

8

Transmission  wavelength and distance

Determined  by optical module

Power Supply

Voltage

DC  -48V;

AC  220V

Power consumption

Consumption

≤20W

Environment

Working  temperature

-5ºC ~55ºC

Storage  temperature

-40ºC ~70ºC

Relative  humidity

5%~85%(non-condensing)

Physical Specification

Size

W×D×H(mm):200×310×44

Weight

≤4kg

Temperature

-5ºC ~55ºC